Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent A. Absolutely! Cuprinol Garden Shades is suitable for any garden structure including summerhouses and log cabins. If it's a bare wood structure, new or old, its probably worth treating it with a wax free wood preservative first to protect the wood from mould, algae and fungi. Allow this to fully dry before painting. Its important than any preservative used is wax free otherwise the paint may not adhere to the structure.

Cuprinol Garden Shades Wood Paint - Fresh Rosemary Cuprinol Garden Shades Wood Paint - Fresh Rosemary

A. It depends on how long ago your shed and fence panels where oiled. Cuprinol Garden Shades paint is a water based product so any remaining oil or wax from previous treatments will likely repel the paint. If the timber hasn't been treated for a couple of years it may be OK. In situations like this we always recommend a test area before starting the main project to test adhesion. Apply second coat as above. The second coat must be applied the same day as the first. If the first coat is left to dry overnight then the second coat will not adhere to the surface correctlyBefore you begin, make sure that you always stir the product thoroughly before emptying the contents into the sprayer and refer to the sprayer instructions for full instructions before every use. Before you begin, ensure that any nearby areas have been covered encase overspray occurs. Any overspray that may occur should be cleaned up immediately with water and household detergent. MINIMUM OF 2 COATS REQUIRED. SUBSEQUENT COATS MUST BE APPLIED ON THE SAME DAY NO LONGER THAN 8 HOURS APART. IF NOT POSSIBLE, LIGHTLY SAND DOWN SURFACES BEFORE RECOAT TO ENSURE ADHESION. Be mindful that it is waxed-enriched and that once these waxes are dried, they act to repel liquids, which would include an additional coats. Don't try to coat the whole project with one coat before getting onto the next coat. Instead it is better to paint sections in in time chunks of 2-4 hours. Don't apply in temperatures below 5°C, in damp conditions or if rain is likely before the product has dried. Low air temperature and or high humidity may prolong the overall drying time of the product. Shake contents of the tin thoroughly before decanting into Cuprinol Spray and Brush sprayer (not suitable for use with the Cuprinol Power Sprayer)

Cuprinol Garden Shades | Cuprinol Garden Paint | Wickes Cuprinol Garden Shades | Cuprinol Garden Paint | Wickes

Q. I want to use a wood preserver on my garden fencing before painting with Cuprinol Garden Shades. Which one should I use? Q. Is Cuprinol Garden Shades suitable for a large log cabin / summerhouse at the end of the garden? Available in an extensive range of cuprinol garden shades colours, it provides a beautiful overall matt finish, and contains special pigments ensuring a rich colour and allowing the natural texture of the woodgrain to shine through underneath. Apply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required. The final colour will vary depending on the surface and number of coats. If adhesion is inadequate on previous coatings, lightly sand before application. Make sure wood has been pre treated with appropriate wood preserver to prevent wood and decay. Q. Is Cuprinol Garden Shades suitable for garden fences and is it solvent-based? Does it contain any wax?Free sachet delivery is available on all Rust-Oleum sachets. These are shipped direct from the manufacturer using Whistl. Can take 5-10 working days. Before full application of Cuprinol Garden Shades, we always recommend testing a small area first, before beginning any project to ensure that you are happy with the colour and overall look of the finish.